Assembly
Progress
What's been done so far:
- Soldered inductor and fuse link and crystal which was missing for knock
- Soldered pin headers for serial, keyboard and LCD
- Soldered both Econoseal connectors
- Soldered wires for supply and connecting GND and GND5 at the board, only for testing
- Made DSUB connectors for serial keyboard and LCD
- Knock and EGT chips are on board
- Initial testing; connecting and communicating with PC, keyboard/LCD communication, updating firmware through bootloader
Apart from a firmware incompatibility issue all is good so far.
28/03/06 Update:
- Drilled frontplate for pneumatic connector
- Updated firmware to 1.0.34
- Mounted MAP sensor, vacuum connection and frontplate to GenBoard
- Did AREF=256 mod, soldering a 33ohm resistor to a trace
- Setup trigger hardware:
- Solder jumper JP2 & JP7
- Solder blob SJ6
- R181 = 100k
- Replaced C103 with 1nF