Already replaced stock Bosch Motronic M2.10.3 with VEMS 3.6. Stock wiring is used for installation, so I had to use Motronic 55 pin connector and VEMS GenBoard. Also some very small adjustments to stock wiring were applied for MAP sensor instead of MAF.
Items used:
1. Vems GenBoard v3.6
2. Alubos case with motronic55 frontplate
3. 8 x Ignition driver
4. 10 x Injector or WBO2 heater driver
5. Idle stepper motor driver
6. Wideband connector
7. Dual channel knock sensor interface
8. EGT amplifier chip
Additionally were bought:
1. Wideband sensor
2. Cheapest external MAP sensor I've found from Reanult Logan.