Audi 80 Avant RS2 working on VEMS for the past 7 months.
working on version 1.1.27 with very stable idle and good setup.
i want to go to vemstune 1.1.62 BUT i have some issues
1) When i open vemstune with 1.1.62 version (default vemsconfig) i try to make changes on various areas and nothing gets saved.
do i have to have the laptop connected to the ECU to make any changes and save them? can i not just do the same as it does with megatune? make all the changes i want, save and then connect in the future to the ECU and send the new config there?
2) If i have 1.1.27 working perfectly on the car,can i use the same settings on 1.1.62 (like trigger,injectors, ignition etc.)? there is audi trigger on 1.1.62 and it is not there on 1.1.27.what will i choose?
3) do i have to recheck with the strobe light again for the timing?
I now have 57Deg after trigger. what settins should i use so that i can have that set correctly?
thanks
8/10/09
I have managed to figure out a few things about vemstune and have copied most of the settings on the 1.1.62 version
new problem:
Vemstune has boost settings for rpm vs map. However, instead of rpm it only allows you to put kPA!!!
so you cannot build an rpm vs boost table!