Just ordered the following items:
- 1 x LCD4x20
- 1 x EGT sensor (K-type)
- 1 x Fuel Pressure Sensor
- 1 x Assembled v3.3 controller
- 1 x BigHarness
VEMS will be used to control an Opel/Vauxhall C20NE engine (2L 8v). The engine is build from ground up. And has a turbocharger now.
Update 10 December 2006:
Received everything. Figuring out the bigharness. Can someone check if the following is correct?
Black injector connector is for knock sensor
Blue connector is for air temp
Yellow connector is for water temp
white plug with three wires:
pink = shiftlight
yellow = ignition switch
gray = rpm signal
2x 3pin connectors are for vr or hall:
black = ground
white = +5V
brown = signal
3 bigger wires in loom with alot of wires:
Green = 1st and 4rd cilinder wasted spark
Orange = 2nd and 3rd cilinder wasted spark
Red = +12V wasted spark
3wire loom for TPS:
Yellow = +5V
Green = TPS signal
black = ground
4 wires with crimp connections:
Orange = clt fan
blue = fuel pump
Purple switches White with relais. You can use it for what you want?
4 injector connectors and wideband connector will speak for it self.
And why is there no serial cable in the bigharness. or at least some spare pins to make a cable. Now i cannot connect my laptop!?