turbocharged 1993 VW air cooled Mexican bug
Hi from Mexico
v3.x Serialnr: .....
Short history of the board
- purchases as assembled or mainboard ?
- ...
I have a few problems with my genboard.
When run VemsTune the software detect the board but pop up a window with legend device disconnected and the firmware upload menu is in grey color
- Verify the RS232 connection, document here your wiring and voltage measurements:
- DSUB9/2 - ...
- DSUB9/3 - ...
- DSUB9/5 - ...
Another thing the volt reg u20 gets very hot and the mosfet drivers gets warm
- this sounds bad
- verify (measure) polarity and supply voltage: ... V
- measure current consumption: ... mA
Make sure to follow instructions.
- is there a chance +12V power was applied without grounds connected properly ?
- we've seen a case this year when GND came off (!) while +12V was applied (so powering GND through some FET outputs and atmega inputs => not good). This is also the reason why disconnecting EC36 under powerup is not allowed (damage is too likely).
See grounds connection:
For assembled board, see relevant info http://vems.hu/download/v3/doc/ (also useful for home-assembled box unless one intentionally deviates)