VemsMT1.0.30rc3.zip
First pass at this has the following results
- Unzipped, flashed with supplied firmware
- Deleted /config/*.mtt
- generate_cofig.bat ran -- no errors
- upload_firmware.bat -- reports: Precompiled version 12x12 Standard Boost
- upload_config.bat -- reports
- config.mtt @2049 char sent
- tables.mtt @ 4017 char sent
- Ran Megatune selected 12x12 standard boost
- VE, Spark, lambda table all report 8x8 in megatune
r028 complete package, with 1.0.23 firmware
- used standard flash and attempt to install technique.
- Initial Firmware flash looks good
- Initial generate config / table _.mtt looks good
- Upload_config looks odd, config is ~17char
- found that WinTools\makeconfig is not working correctly
Mantt mcs bye
Ran r30 \Tools on r28 distribution it at least reported errors ( complained about shiftcut)
Currently under Beta test for emil_
VemsMT1.0.34-testingonly.zip
emil_ provided a download place for me to test.
Givens:
- I have several versions of MegaTune installed.
- I am pretending to be a user for installation and use
- I will not be compiling anything -- only precompiled firmware
- To test I need a complete zip file that has everything where it needs to be already.
- /config with contain default config.txt and tables.txt
Proposed Check sequence
Steps to be checked
- Unzip file
- delete /config/*.mtt
- run in the following order
- upload-firmware.bat
- generate-config.bat ( check for valid table.mtt & config.mtt )
- upload-config.bat
- start provided MegaTune and ensure communication
- run megatune review mode
- report errors
Configuration changes from MegaTune
- change primary trigger setup to 60-2 VAG wheel
- change injector output to batch
- change ignition output to wasted spark
- check redline
- check fuel pump control output ( INJ fet and S259-5 )
- Trigger unit and make sure it reads values
- WBO2
- Check pump_zero
- Calibrate o2%
- Breath test
- Output configuration
- INJ change to 2 or 4 bank outputs re-arranging combinations of outputs ( firmware people should suggest combination checks )
- ING change 2 or 4 wasted spark setups (ie. wasted spark COP or is this the dual_ign mod??)
Test Results:
- using 1.0.34 combo.
- VE in realtime display
- MAP is constant (= ?), RPM varies (from .. to ?).
- Set VE to 131 in all RPM position in particular row (#3 up from bottom)
- full mct dump ? (ve and k and r tables too)
- VE varied from 128-133
- Set VE in table to 131 in all positions
- from Row#1 -- Row #5
- VE in RT display varied from 129-130
- Full mcd dump ? Particularly, kpa_conf is interesting. With wrong kpa config unit, the experimental megatune might say "20 kPa" for a line which is in fact for 40 kPa
Basic results:
- deleted *.mtt files in \config
- generate_config.bat reports 2 errors
- iac_integral_speed in config.txt not in global
- did not find launch_rpm in config.txt
- generate_config.bat made *.mtt files
- upload_firmware.bat reports: Precomiled version reports 12x12 standard boost
- flash successful
- turn off advanced filtering and works fine.