Dear Vems,
You provided pictures and great explanations to add 2 analog inputs thanks for that.
But I saw that I already have 2 existing green wires on my 3B board that share one extremity of your 2 red drawn on the board.
What shall I do with these wires? I also have light green and orange wires at the position of your proposal for a analog ch2 and ch5.
I have added in colours on your picture the existing wires (black, light blue, blue, grey, orange, red)
that are going from the board to the existing sc6 connector.
Maybe I do not have to do any modification on the board ? Are the existing wires (black, light blue, blue, grey, orange, red)
input already available from factory ? output ? pull up ?, protected ? which channel ?
many thanks.
Lolo
Getting extra analogs
Do these to get 2 pcs. of 0-5V analog inputs.
- solder 2 wires to the bottom of the board like on this image:
-
- Remove the two resistor marked cyan and solder two 10kOhm resistor marked black on this image:
- The two resistors are the pullup resistors to the two analog input, so if remove them, the analog inputs are become only protected.
- wire EC18 pin 2 and pin 3, this way you can use analog in ch2 and ch5