Here you can report issues with your Genboard V3, firmware, tuningprogram or hardware problems.
If you dont know, put it under Unknown.
Firmware:
Hardware:
- 2005-08-10 - Possible fried injector driver
- on Werners volvo 140, with 2.5 ohm injectors with PWM activated, 40% 1.5 ms pwmt
- After a wiring problem (ground or flyback) and upgraded MAP - sensor, we got strange lean misfires at higher load/pulsewidths, these problems was moved up in boost level with a raised injpwmt, but does not fix the problem (tried as high as 15mS for a short moment, to never get into PWM mode..). We have probably fried something, should i start measuring somewhere? Or change all FET-drivers and FET's that are involved ?
Tuningprogram (Megatune):
- 2005-06-23
- Alha-n tuning is not working ? Megatune ->useing MAP not TPS load the VE-Tables.
- Ini file -> vemsv3_v13_r021.zip
- firmware -> 1.0.13 rc3
- possible solutions:
- Developers are working on making firmware report load instead of the current kpa
- If you are running alpha-n only and not hybrid mode, its possible to modify vemsv3.ini to show TPS in the realtime tuning, write here or memberspage if you need help.
- thanks for the info.I'am useing Alpha-n only, yes I need details how to modify vemsv3.ini
- 2005-06-22 EmilLarsson
- Firmware -> v13rc5, precompiled.
- config + tables http://kombi.ulkhyvlers.net/vems/roland/
- LCD Display works with genboard powered, engine not started, but after the engine is started, it stops working, sometimes blank, sometimes full of rubbish
- possible solution:
- Will try a capacitor between VCC and GND on the display-side