Here you can link your report issues with your Genboard V3, firmware, tuningprogram or hardware problems.
Make your report on your MembersPage, and place link in the relevant section (with a "title", so it can be remembered easily). If you dont know the section, put it under "Unknown".
In the report, include at least:
- board version, serial Nr.
- firmware version
- MegaTune version (when MegaTune is used at all)
- intended config.txt (possibly commented)
- mcd.txt (captured output of Manmcd command.) This is the live config. Very important, since in a bad case it can be different from the intended config (if you used a global.h from a different firmware version; or there is a MegaTune configuration problem, etc...)
- description of the problem
- your investigation so far
- any ideas to proceed
The report, to be considered, must contain all necessary info. Without the necessary info, question-answer iterations are needed, so solution is delayed (in the best case).
Hardware: - usually wiring. These are normally answered even if you only use your MembersPage, but if you insist...
- ...
Config: - These are normally answered even if you only use your MembersPage, but if you insist...
- ...
Firmware:
- A low temperature ( lower than -40degC) will show up as 76 degC and cause misfiring, we should also make sure to include properly calibrated tables for the NTC sold in webshop, as the real temp probably was a bit warmer than -40) //Emil
- ...
Tuningprogram (Megatune):
- 2005-09-21 iac activation flag is inverted (Fero reported on phone): not sure which one, the (ON/OFF vs. PWM-stepper - likely) or ignition advance based idle active/OFF
- 2005-09-02
- EGT display (range) is bad, the gauge displays upto 256C (the digital display is good, but the gauge rails out)
- injector duty cycle... is this fixed already ?
- 2005-10-23
- In alphaN-mode, at 22% throttle (VE, lambda or ignadv table) 56 kPa (255 * 22%) line is used. However MegaTune shows 117 kPa ( 512kPa * 22%) and places the dot at a different place, Tunable, but very confusing
- Ini file -> vemsv3_v13_r021.zip or up to mt-r027
- firmware -> 1.0.13 .. 1.0.18 .. 1.0.22
- possible solutions:
- fixed in next release: when reporting load, in comm.c A command offset 4 and 5, <<2 used instead of <<3 from 1.0.23. User must still be aware that MAP gauge only shows MAP when RPM > hybrid_rpm_m and load otherwise
- in the future, firmware might report load and kpa in different positions (the dot should always move according to load, MAP gauge always display MAP)
- If you are running alpha-n only and not hybrid mode, its possible to modify vemsv3.ini to show TPS in the realtime tuning, write here or memberspage if you need help.
- thanks for the info. I'm useing Alpha-n only, yes I need details how to modify vemsv3.ini
- Megatune Accel wizard display shows current TPS instead of changespeed of TPS.