Input Trigger/Subaru Trigger - VEMS wiki www.vems.hu

InputTrigger/SubaruTrigger (2008-09-01 09:20:51)

Subaru Trigger => See InputTrigger/ShortGapTrigger for config details

Works with the (pictures at the bottom) 6 tooth crankwheel and 7 tooth camwheel (and 1.0.x firmware).

see MembersPage/MichaelRichards/Projects/SubaruECU
- Seen on North American Legacy Turbo and the 2.5L SOHC plants (definitely on 99-01 plants, maybe on 02-03 plants and possibly earlier)

360 teeth not supported - the rest needs clarification. (separate page?)

Older Subarus(L-Series) with ECU controlled ignition have Crank-position [Signal disc] in distributor.

360 little holes in outer ring presents Crank-angle in one degree/Percent precision (For engine speed signal)
- 360 pulses not supported. Rob made signal disks with less pulses, maybe they can be installed

Four long holes, are crank angle signal. One of the holes is longer, indicating (possibly) Cyl 1. (Working on it!!)

36-2-2-2 setup (36 crank teeth, missing 2 teeth BTDC Cyl 1, and 2 teeth twice before BTDC Cyl 3, exact angle needs TBD). Seen on North American 2.2L SOHC plants (99-01 model using 2 teeth cam wheel) as well as other 2.0L/2.5L Turbo plants (most using 4-1 cam wheel)

Q: Any ideas how to make it work with genboar v3.0??

A: the 360-3 tooth crankwheel is definitely more than what current firmware can handle (and possibly above what is practical with the chosen inputcapture - but not HW-counting capable - IC1 channel). I suggest to help out in the InputTrigger/AudiTrigger

firmware, that board was designed for this.

Supported :

Newer subarus (Legacy mark1) have triggers like these:

[Cam Sensor]

[Crank Sensor]

7 tooth cam wheel:

6 tooth crank wheel:

This is a subaru Impreza WRX 2001-

CAS and Cam wheel

can someone make a trigger setup with this?, firmware 1.0.78 or what´s needed to make a working trigger config?

Thanks skassa