What to measure and what to think about when running secondary trigger VR on a 3.2 or 3.3
- is the correct solder jumper installed?
- SJX
- is the sectrig LM1815 pin7 adaptive threshold RC circuit soldered on fine ?
- check the schematic
- Don't forget to look for missing components, especially the 0805 resistor from LM1815pin7. 100 .. 180k is fine, or even a 0k short.
- What signal does the LM1815 output to the AVR on IC3?
- Should be a 0/5V square waveform, only 5V for a short 60usec after the input negative going edge
Make a report of your measurements. All pins.
Emil's board
v3.2, standard, Earlier trigged by primary trigger VR in a car. I just understood that i need to install some more components around this, which ones are needed? havent found any guide in the wiki for this.