I have used motec on GSXR1000 last year in a team which I had worked in. Motec M-800 is great but it is expensive. Genboard seem to have same or superior hardware specifications. 
NEW, Motuner ecu tuning software MembersPage/JoseLCortes/Motuner Genboard Racing Functions MembersPage/JoseLCortes/GenboardRacingFunctions GSXR1000RK3 Engine Sensors Description MembersPage/JoseLCortes/EngineSensorsDescription Ignition timing accuracy test with Genboard_v3/Firmware2004-11-24_v11_2 MembersPage/JoseLCortes/IgnTimingAccuracy My engine started with Genboard working in fully sequencial ignition (with COP´s)!!! MembersPage/JoseLCortes/FullySequencial Motorcycle Engine eddy current dynamometer MembersPage/JoseLCortes/EngineDynamometer
||
|| ||122_2281.jpg||122_2289.jpg|| Our mision is to install a Motec, but I hope to get install and test genboard in this engine, it is completely new engine, from a absolutely 0 km motobike!!! 
First cycle strange firing sequence report 17-October-2005
The first turn during crancking seems to apears strange firing sequence it makes a ugly explosions during start process and dificult the starting process. I have checked that it is not a ground loop or any electromagnetic noise. (in fact, now i am testing it with a simulator) * latest firmware version used: v3_firmware_1.0.18 * http://www.nmine.com/msavr/config.txt (updated 17-10-2005) * http://www.nmine.com/msavr/tables.txt (updated 17-10-2005) *h[2]=03 02 01 00 03 02 01 00
The above config file has some questionable settings, this is what I came up with for that engine: tooth_wheel=07 # 8-1 teeth trigger_tooth=01 another_trigger_tooth=04 crank_minper=40 # FF is too high, FF would cut spark at high-RPM tooth_wheel_twidth1=0A #decimal 10: 45 degrees (0-720deg = 0-160 fake degrees) tooth_wheel_twidth2=14 #decimal 20: 90 degrees. This assumes reset_engphase_after (720 degrees) is decimal 160 (hexa A0) cam_sync_r_edge_phase=0A cam_sync_f_edge_phase=0A reset_engphase_after=82 # ???? decimal 130 ???: The trigger tooth after the trigger tooth at 540 degrees (585 degrees) 585/720*160=130 (82hex) Why not decimal 160 ? -Jörgen
I have no multichannel oscilloscope so I built a "channel multiplier" with resistors: -Ign Channel 00 - 9.4k lower pulse -Ign Channel 01 - 4.7k -Ign Channel 02 - 2.2k -Ign Channel 03 - 1k higher pulse
It is diferent than old testings, this time the sequence is always exacly the same. Only two ignition firings are erroneous. Jose L Cortes joseluis_jlc at hotmail dot com[...]