[[Manual: Basics.Install.Mechanic]]
Soldering steps of the mintest:
- o Ohm resistor on the bottom
- R154 under the atmega
- LCD capacitor (C89)
- Big Vbatt capacitor (C72)
- Big troughole diode
- quartz 16 Mhz
- connect the GND-s
- pinheaders for the ISP
- do the firmware things and checks
Soldering steps after the mintest:
- big black barrell inductivity
- knock chip
- quartz 4 Mhz
- main fuse wire
- stepper chip
- stepper capacitor (C75)
- stepper Vbatt wire in the place of D45
- two trigger zeners (D14, D27)
- trigger1 pullup resistor REMOVE (R55)
- configure the trigger1 to VR, and the trigger2 to HALL
- flyback diodes
- wire out the knock the RS232 and the MAP signals into the EC18
- FETs,IGBT, EC connectors
Back to GenBoard/Manual