Some v3.6 (or newer) Sectrig=HALL notes (excerpts from GenBoard/Manual/InputTriggerHardWare)
Unsolder SJ7
- if you had sectrig=VR or sectrig=auditrigger (and converting to secrig=HALL), than also
- open SJ7 solder-blob on the bottom, so LM1815pin12 output is DISconnected from the microcontroller input pin. This blob is on the bottom, close, to the line of FETs.
- actually this is the only step required if converting from sectrig=auditrigger (because that already has the HALL part of the circuit set up from EC36/13)
- the instruction says: all 5 throughole pads in the middle must be empty
- note: jumpers are also like wires, might need to reconfigure if they were configured for VR
Verification, R48, connecting the right signal to EC36/13 pin
- EC36/13 sectrig input pin should be connected to the proper side of R48 (the other side of R48 is +5V)
- Should measure 3.7V or higher (absolute min 3.3V) at EC36/13 (or the CPU side of SJ7) when powered up and input not connected
- If you pull down the signal with a 1kOhm resistance, than measured DC voltage should be minimum 870 mV (voltage divider equation: U=5V * R/(R + Rpullup))
Verify in InputTrigger/TriggerLog