My own street car. It works with VEMS since 2018.
- VEMS 3.8b (diy kit)
- firmware: 1.2.38
- hc-06 bluetooth (diy)
- 7 inch screen built in 1 din car audio
- Engine: 2.2 MC stock bottom end
- Cylinder head: OEM with ARP Head Studs, FCP springs, Inconel valves
- Intake: Custom dual plenum intake (like 200 trans am)
- Exhaust: Custom header, 2,75 inch pipes, 1 muffler
- Camshaft: custom 272 lobe;
- Ignition: Audi TFSI COP
- Primary trigger: 60-2 VR(volvo 2 wire sensor) custom trigger
- Secondary trigger: OEM distributor with 1 teeth
Pinout:
- TPS
SIGNAL pink/white
5v+ ref pink
- CAM
SIGNAL pink/white
5v+ ref light red
- CLT
SIGNAL blue/black
- MAT
SIGNAL blue/yellow
- IDLE
SIGNAL white
- CRANK
SIGNAL grey
sensor GND black/white
- INJ1
SIGNAL yellow/grey
- INJ2
SIGNAL yellow/brown
- INJ3
SIGNAL yellow/purple
- INJ4
SIGNAL yellow/red
- INJ5
SIGNAL yellow/white
- COIL1
sensor gnd black
SIGNAL green/black
gnd yellow
- COIL2
sensor gnd black
SIGNAL green/white
gnd yellow
- COIL3
sensor gnd black
SIGNAL green/red
gnd yellow
- COIL4
sensor gnd black
SIGNAL green/yellow
gnd yellow
- COIL5
sensor gnd black
SIGNAL green/brown
gnd yellow
- O2 4.9
ec18 pin7 yellow
ec18 pin13 black
ec18 pin18 white
15+ fused grey
- check/warning light output ec18 pin4 white (gnd)
- launch control input ec18 pin2 analog ch5 black(gnd)
MAIN RELAY
FUEL PUMP RELAY
The car runs great. Boost pressure is now 1.6 bar. Great power-band 3500-7000 rpm.
My goal is build one of the most powerful 10vt audi In hungary.