This will be a ongoing discussion on the build up of a new VEMS V3.3 and build of a wiring loom to handle a M20 or M30 engine in a BMW E30 series.

Loom will be able to handle a stock NA engine as well as a Forced induction setup along with boost control, wideband signal and EGT signal. Loom will be able to be installed into any E30 with a identical C101 plug (where the engine loom connects into the car).

Install when loom is ready should take about 30-40minutes.

_____________________________________________________________

Update 29.Oct.2007

Before anything is done one needs to install the remaining components, wich are only few on the V3.3 board vs. the older ones.

http://www.vems.hu/wiki/index.php?page=StepByStepGuide

Shows most of the information I was looking for, whilst I still need some more information.

Question with answers in the StebBystepGuide

#1. Installation of the FET and IGTB´s and final look before installing the board into the case.

#2. And where do IGTB´s go and where to the FET´s go.