While i have been data logging in the past, I have found it difficult some times to pin point areas that i was concerned about whilest driving the car. I have installed the Shift cut and ALS input switch and noticed that when the switch is enabled on the shiftcut settings with the ignition and fuel cuts disabled, the shift cut switch light still shows on the data log.

The idea is to fit a momentary switch to the steering wheel, enable the input channel and dissable igntion and fuel cut in shift cut settings. In doing so, if there is a point while driving and logging, that i am concerned with and want to look at in the log later, I can press the switch and mark the points of concern.

----

Link back to MembersPage/Sprocket