Changes by last author:
Added:
|
*Green Stuff Brake Pads
*Aluminium Front Wheel Hubs |
| *Rover LT77 (heavy duty ) gearbox |
|
*Ford Cosworth T5 gearbox
*Tilton Concentric Slave Cylinder |
|
*Westfield Sports Seats
*Westfield Contoured Dash *Westfield Boot Box *Westfield Hood |
|
  
|
|
*Double Valve Springs
*Act Carbon Fibre Plenum (71mm inlet) |
| *Polished & ported 48mm trumpet base |
|
*Polished & ported 48mm trumpet base (Aluminium Shorted Trumpets)
*Thermal Plenum Spacer |
|
*Billet Rocker Posts
*Steel rockers (Fed Mogel) *Gems Roller Timing Chain |
|
*Modified plenum chamber (standard bore)
*Trap door lowered sump *Gems flywheel with rear pickup ** what primary trigger pattern ? 36-1(trigger 20deg from tdc) |
|
*Modified Throttle Housing (71mm)
*Trap door lowered & Baffled sump *Gems flywheel with rear pickup (36-1 trigger & 80deg BTDC) |
| *220cc injectors |
|
*220cc Bosch "Red Devil" Injectors
*10.1 Compression Ratio *Varley Red Top 30 Battery *Poly Engine Mountings |
|
|
| Vems Spec |
| Vems ECU Spec |
| *Genboard V3.3 |
| *Genboard V3.3 (V1.2.43 Firmware) |
| *1off Throttle Switch |
|
*1off lambda sensor
*EGT thermocouple *4 coils runnings wasted spark |
|
*1off MAT Sensor
*1off Coolant Sensor *1off Cam Sensors (Hall) *1off Crank Sensor (VR) *2off Bosch lambda sensors (LSU4.2) *1off EGT thermocouple (type K) *4 coils (wasted spark) *Bosch Fuel Injection Pump *Bosch 3 Bar Fuel Regulator *Oil Pressure Output *Tachometer Output *Vems External Memory Card *External GPS Logging On 2nd Serial Port *Bluetooth Adapter & Android App |
Picures and latest config & vemslog can be found here *https://vstuff.virginmedia.com/n/50-17/share/LNK55264c0a2536beb1d/ More pictures can be found here. http://s875.photobucket.com/albums/ab319/seight-v8/Westfield%20Kit%20Car/ |
|
|
  
|
|
|
| 2011 Upgrades (hopefully to include) |
| 2011 Upgrades |
| * Full camsync using either a modified front camshaft sporket or using orginial land rover GEMS efi sprocket, but this uses 2 pulses per revolution, and i am hoping new firmware might enable me to use this at sometime in the future. |
|
* Full camsync using either a modified front camshaft sporket or using orginial land rover GEMS efi sprocket.
2013 Upgrades *Bosch "Red Devil" EV6 Injectors (220cc) *Westfield Sports Seats *Westfield Harnesses
2014 Upgrades *Bluetooth serial adapter for mobile phone datalogging while driving.
2015-2018 Upgrades *Top hatted Block *Pocketed Pistons (Valve Cutouts) *Full dynamic Engine Balance *Ford Cosworth T5 Gearbox (Rebuilt) *Westfield T5 Propshaft *Tilton Concentric Slave Cylinder *Tilton Clutch Master Cylinder *Gems roller timing chain *10.1 Compression Ratio *Cometic Head Gaskets
2018 and on *Run new rebuilt engine & gearbox in for 500 miles, then look to proper tune ECU on rolling road for optimum performance. 2019 *Loads of upgrades which include:- *New alloy uprights and cycle wing brackets *New front & rear brake calipers (red) *Rimstock +100 wheels (original westfield ones) *LED front headlights, with halo DRL *LED rear lights *LED front indicators *LED side repeaters *Drilled & grooved rear discs *Pipercross venom sealed air filter with cold air feed, *Moved air temp sensor to before air filer and replaced hose with silicone version, to reduce heat soaking *New bosch lambda sensors *New air temperature sensor from the VEMS shop. *Moved GPS sensor on to top of dashboard, to get better GPS lock *Front & rear suspension geometry re-set, ride height, camber angles & toe settings. *New front upper suspension ball joints *Super unleaded RON99 fuel *Firmware V1.2.43 loaded and running....problems with memory card logging not working, only a triggerlog is saved, even when this is "Disabled" in the ECU logging settings, so must be firmware related. More pictures can be found here. |
