Changes by last author:
Changed:
|
1 x WB02, with heater control - I need to use No. 18?
4 x injectors, [Semi] Seq, can I use B,C,D,E or do I have to use A,B,C,D ? 1 x wasted spark coil pack, do I have to use 00, 01 or can I use 02 & 03? I think thats it for now :-) |
|
* 1 x WB02, with heater control: use EC18/18
* 4 x injectors, [Semi] Seq, can I use B,C,D,E or do I have to use A,B,C,D ? ** BCDE is fine, but more common to populate all 8 injector FETs: these are very useful, and more rugged than - say p259 outputs. Control inductive loads like relays (eg.fuel pump relay ) with injector output, than the flyback protection is there *** if using p259 output for relay, solder diode anode to the output and diode cathode to the constant +12V of the relay. Not needed when driving a LED. * 1 x wasted spark coil pack, do I have to use 00, 01 or can I use 02 & 03? ** actually 2 & 3 recommended, so that it is compatible with preassembled controller (check WebShop) when ordered with 2 IGBT |
| Personally I'd do them A B C D... but then I fill the board up so that I have room to expand should I want to drive other solanoids at a later date. |
| Personally I'd do them A B C D... but then I fill the board up so that I have room to expand should I want to drive other solenoids at a later date. |