1) To take triggerlog, first apply the following config changes, burn and power cycle ecu afterwards:

* primary trigger config:

** special trigger type: normal

** tdc after trigger: 60 deg

** number of teeth of full cycle: 129

** first trigger tooth: 0

** next trigger tooth: 43

** angular width of tooth: 2.75

** all further drop-downs below disabled.

2) Than proceed to taking triggerlog in format:

* engine cranking 8-10 seconds without INJ and IGN fuses

3) Upload triggerlog here, also provide vemscfg of configuration used during taking of the triggerlog.

After receiving the required data to facilitate remote review of your trigger issue, i will start investigation.

Best regards,

Dave

----