Changes by last author:
Changed:
|
1 vr cranksensor 12 teeth
1 vr cam sensor 1 teeth inj cyl 1 on injA inj cyl 2 on injF inj cyl 3 on injG inj cyl 4 on injH |
|
24+1 trigger * 1 vr cranksensor 12 teeth * 1 vr cam sensor 1 teeth ---- Outputs * inj cyl 1 on injA * inj cyl 3 on injG * inj cyl 4 on injH * inj cyl 2 on injF |
|
cyl1/4 on pin 34
cyl2/3 on pin 36 |
|
* cyl1/4 on pin 34
* cyl2/3 on pin 36 |
| If i rev up to 3000rpm, a status bar in megtune states "missfire". However engine runs well. Could this be because same ign-output appears twice in hardware map? |
|
If i rev up to 3000rpm, a status bar in megtune states "missfire". However engine runs well.
* Could this be because same ign-output appears twice in hardware map? ** No. "wheel error" is related to trigger input. Having same ign-output at several places in h[2] is OK, and should not cause wheel-error |
| my config : |
| my config (as far as trigger concerned, which config did you start from ?): |