History of MembersPage/MarcelWolf
Older Newer
2017-11-10 22:17:38 . . . . MarcelWolf [Added LCD customizable wish]
2017-11-10 21:39:22 . . . . MarcelWolf [fixed typos]
2017-11-10 21:35:56 . . . . MarcelWolf [added forum bug]
2017-11-10 21:32:59 . . . . MarcelWolf [added bugs + wishlist]
2017-11-10 21:06:49 . . . . MarcelWolf [minor changes]
2017-11-10 20:41:19 . . . . MarcelWolf [changed apperance]
2017-11-10 20:30:26 . . . . MarcelWolf [Created]


Changes by last author:

Added:
||1989 Porsche 944 Turbo 2.5 8V||

CONTROLS + Sensors

*VEMS V3.8 Firmware 1.2.38 VemsTune 1.5.55

*Onboard 300kPa MAP sensor

*Ordered as VR trigger, converted to hall

*Cherry/ZF electronics GS100102 Hall effect crank sensor, 1.5mm gap

*Audi hall sensor as cam sensor

*OEM clt sensor

*Fuel pressure sensor

*oil temp sensor

*Wheelspeed from gearbox

*E85/98RON Mapswitch

*Analog Input Multiplexer

*2x EGT onboard + 2x EGT amp

*LSU 4.9

*OEM Bosch knock sensor

*Pre compressor temp + pressure Bosch 0 261 230 215

*Pre IC pressure + temp Bosch 0 261 230 215, will switch for higher MAP range soon

*Post IC pressure + temp (IAT) 0 261 230 215, will switch for higher MAP range soon

*LCD

*New engine harness utilizes OEM breakout connectors + fuses and controls OEM relais

CAR

*Bosch 0 280 158 040 980cc/min injectors @ 4bar (~1120cc/min)

*Pierburg fuel pump 7.00228.51.0

*Bosch 0 280 160 263 4 bar fuel pressure regulator

*modified flywheel with 60-2 trigger and -55% inertia compared to stock

*3" from turbo with 100cpsi catalytic and modified stock muffler

*piston oil squirters

*100.5mm Wössner pistons

*closed deck block modification

*Stock RARST rods

*Stock Head + NA cam

*NGK BPR7E sparkplugs on E85 @ 0.5mm gap (was BPR8E on high boost + 98RON)

*BorgWarner EFR7163 Twinscroll IWG with custom x-over pipe

*6spd Audi TDI gearbox swap

*597060 wasted spark ignition coil

*Nissan Quest Alternator swap

*Sachs Performance clutch

Bugs

*AI Multiplexer CH A1: calibration mode: curve --> no function demuxed_chA1_cal-mat; I think it needs to be mat-demuxed_chA1_cal

*can't register to vemssupport.com/forum: no email is send to my account, spam filter and all stuff is turned off

Firmware wishlist

*multiple custom sensor curves possible

*possibility to rename AI channels

*create virtual channels from several channels with basic mathematic operators (not only display them by custom expression)

*delta to lambda target instead of fixed lean threshold for warning light? 2D map: difference vs rpm or 3D map: Lambda warning threshold vs MAP(or TPS for AlphaN) vs RPM

*Customizable LCD pages