Changes by last author:
Changed:
|
Q. TDC is 84° after rising edge of primary trigger. Ignition advance gets up to 55°. Now Coil charge time gets down to about 1,5ms on 6500rpm but i want at least 3ms. Is there a way to start charging before the rising edge?
Q. Does anybody has working Tables on this engine? Because my Genboard does exactly the same as factory ECU but the engine doesn't run good. Q. Is there a way to change the starting point of fuel injection? |
|
* TDC is 84° after rising edge of primary trigger. Ignition advance gets up to 55°. Now Coil charge time gets down to about 1,5ms on 6500rpm (what firmare + config?) but i want at least 3ms. Is there a way to start charging before the rising edge?
** yes, easier with 1.0.x (either with dis ignition or distributer). Harder with 1.1.x firmware (in any case, if 1.1.x, try on bench first !) * Does anybody has working Tables on this engine? Because my Genboard does exactly the same as factory ECU but the engine doesn't run good. ** maybe the problem is not fuel or ignadv but dwell ? Or idle settings ? * Is there a way to change the starting point of fuel injection? ** rotate h[0] |
| *4+1 Cam Sensor |
| * 4+1 Cam Sensor |