Changes by last author:
Added:
|
I'm looking to build a VEMS controller for my S6. I know they are available built, but I would like to do it myself and I figure it will be a lot cheaper. I need to compile a parts list.
1 x Power Flyback 1 x 250-400 kPa MAP sensor 7 x Injector or WBO2 heater driver 5 x Ignition driver 1 x Idle stepper motor driver 1 x JPT55 connector 1 x Dual channel knock sensor interface 1 x Alubos gasket 1 x Alubos1600 1 x Alubos Endplate 1 x GenBoard v3.3 I also need a front plate for the JPT connector. Are any of these parts redundant? Are they already included in the GenBoard v3.3? Am I missing anything? Where can I find information on assembling the above parts? I have been looking at the wiki but don't find much yet. |