Systematic secondary trigger debug.

The LM1815 has been removed twice from this board (likely unnecessarily). I suggest not to solder back the LM1815 (or remove it if it's there or remove anything else) until the actions are planned in wiki (preferrably ask on irc to get them reviewed by someone).

Hide the solderer, or at max unsolder SJ7 if the LM1815 is on at the moment.

Visual review

I cannot spot anything suspicious:

The pad (that goes to 2nd LM1815pin3 through the rc filter) might be shorted to GND with some blob (hard to tell visually). You had the crankhome VR soldered there.

* Why was it removed?

* make sure it's not shorted to GND when you connect the crankhome VR signal back.

* you replaced 18k with 10k. Good

* the cap is original ? or changed? 2.2 nF?

* IC3 trace.

* LM1815pin12 output (don't solder the LM1815 on, and don't remove it if there "at the moment" :-)

* the SJ7, the jumper between IC3 and LM1815pin2

** measure the two sides of SJ7 if SJ7 not soldered

With the chip removed, or SJ7 unsoldered, IC3 must be pulled up to appr 4V (min 3V). This is done by 2 pullup resistors.

If IC3 voltage is less than 3V (not pulled up sufficiently),

* there might be something wrong with the cam-HALL input (grounded?).

* try to pull up IC3 to 5V through a 10k resistor, and measure voltage again (to see if it's strongly pulled towards GND, or just "not pulled up".)

The LM1815pin14 pulse you talked about (on irc: note that it's easy to misunderstand there) indicates that the LM1815pin3 pulse is sufficient (goes below 0V) to trigger the chip.

I find it likely that the HALL pulls the IC3 down, and therefore even when LM1815 releases pin12 output as it should, there is not voltage rise to 3V or above (to trigger the AVR input). Note that the LM1815 does not emit a positive output on pin12, just releases it (open-drain), therefore relies on external pullup. If something (like HALL input, or a solder bubble) "disables" our pullup, we cannot blame the LM1815 chip.

----

All sensors original except for map/iat: Bosch 0 281 002 437

Firmware 1.0.29 00:21

** does this have the same trigger-config as running on 1.0.30 ? Can you publish uptodate config in mcd dump format - thanx

* Tables http://linkopingsmotorsport.se/1029/tables.txt

It turned out that the 135 tooth noise to the crankhome is inserted outside the ECM (with connector removed, it was still there), in the cable or ground.

Even if it might idle after some hacks, finally the noise from crank-VR must be eliminated, hints on InputTrigger/AudiTrigger/TestLM

It's unacceptable to use

* shared (between crankhome and 135 tooth crank)

* or nonshielded

* or badly shielded (eg both ends!) cable

* or bad ground

with this setup