Changes by last author:
Added:
| BOM for MembersPage/BasilDaham/CordobaSX |
| **6+2 ignition config |
| **6+2 ignition outputs 4+4 sounds more suited for the 4cyl. Even if only 1 is used originally (distributer), and 2 (wasted spark) is best (most powerful and durable transformers available that, even with the 10% waste, output higher energy than COP coils in an inductive ignition application) for most 4cyl installs |
| **300kpa onboard 5/3mm |
| **300kpa onboard 5/3mm note that 6/4mm nipple is more common, check again what is best for you |
| *I'm assuming this is all the kit I need to make a loom: |
| * The kit needed for a loom: |
|
**two wideband connectors (i'll crimp my own wires with the above tool as long as the recepticles are included in the wideband connector kit, otherwise please send the one with crimped wires)
**two 3-pin simple wire to wire connector (pair) **four 2-pin simple wire to wire connector (pair) |
|
**two wideband connectors (receptacles included, of course)
* simple connectors: (note that SSC sealed sensor connectors are MUCH better, the simple connectors are not sealed and look lame ; more suited for bench / prototyping stuff) **two pair 3-pin simple wire to wire connector **four pair 2-pin simple wire to wire connector |