working on version 1.1.27 with very stable idle and good setup.

i want to go to vemstune 1.1.62 BUT i have some issues

1) When i open vemstune with 1.1.62 version (default vemsconfig) i try to make changes on various areas and nothing gets saved.

do i have to have the laptop connected to the ECU to make any changes and save them? can i not just do the same as it does with megatune? make all the changes i want, save and then connect in the future to the ECU and send the new config there?

2) If i have 1.1.27 working perfectly on the car,can i use the same settings on 1.1.62 (like trigger,injectors, ignition etc.)? there is audi trigger on 1.1.62 and it is not there on 1.1.27.what will i choose?

3) do i have to recheck with the strobe light again for the timing?

I now have 57Deg after trigger. what settins should i use so that i can have that set correctly?

thanks

-----------------------------------------------------------------

8/10/09

I have managed to figure out a few things about vemstune and have copied most of the settings on the 1.1.62 version

new problem:

Vemstune has boost settings for rpm vs map. However, instead of rpm it only allows you to put kPA!!!

so you cannot build an rpm vs boost table!

-----------------------------------------------------------------

11/11/09

it seems that vemstune 2/10/09 does not have this problem. Only the latest version of it has the problem with the kpa/kpa boost curve.