Changes by last author:
Changed:
| * Lambda table does not work good. fixed MT ini used incorrect page reading lambda table. Also firmware fix for unitialized variable in table reading committed to both branches. |
| * DONE: Lambda table does not work good. fixed MT ini used incorrect page reading lambda table. Also firmware fix for unitialized variable in table reading committed to both branches. |
|
* the Kpa readings doesn't work good if i use kpafac and kpaoffset - possible solution below - DB
* the firing sequence during cranking is not right too (in megatune?) in firmware this is believed 2b fixed |
|
* DONE: the Kpa readings doesn't work good if i use kpafac and kpaoffset - possible solution below - DB
* DONE: the firing sequence during cranking is not right too (in megatune?) in firmware this is believed 2b fixed |
| * "Boost solenoid off below this pressure", and the boost table boost bins are divided by two. So if you set 70 Kpa boost than the boost target will be 140 Kpa. |
| * DONE: "Boost solenoid off below this pressure", and the boost table boost bins are divided by two. So if you set 70 Kpa boost than the boost target will be 140 Kpa. |
|
* make a "knock gauge" in megatune, it would be very helpfull in tuning. During tuning, i always watching the knock diff characters in the LCD, but lcd IS TOO SLOW to correctly realize knock. So i think megatune Knock Gauge would be necessary.
** I had no idea that knock was working at all, if someone helps me with the firmware part, i'm ready to make a new megatune + firmware release on monday, who can write a simple knock config howto ? //Emil |
|
* DONE: make a "knock gauge" in megatune, it would be very helpfull in tuning. During tuning, i always watching the knock diff characters in the LCD, but lcd IS TOO SLOW to correctly realize knock. So i think megatune Knock Gauge would be necessary.
** I had no idea that knock was working at all, if someone helps me with the firmware part, i'm ready to make a new megatune + firmware release on monday, who can write a simple knock config howto ? //Emil Rob is working on a knock setup section in MembersPage/PhatBob/UserGuide |
| * since 1.0.63 the logged ignadv is 128+ignadv_halfdeg (this allows +63.75 .. -64 deg where positive is normal BTDC): |
| * DONE (fixed in svn) since 1.0.63 the logged ignadv is 128+ignadv_halfdeg (this allows +63.75 .. -64 deg where positive is normal BTDC): |