__      __
 \ \    / /
  \ \  / / 
   \ \/ /  
    \  /   
     \/    
           
           

         
         
  #####  
 #       
  ####   
      #  
 #####   
         

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

 _ 
(_)
| |
| |
| |
(_)
   
   

______ 
|  ___|
| |_   
|  _|  
| |    
\_|    
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
---- low priority: '''More than 6 gears displayed in [http://www.vems.hu/android/ VemsDisplay]''', sequential gearbox Some sequential gearbox have 8 gears, voltage climbing in this order: * reverse (lowest voltage) * neutral (0) * gear 1-6 original "request" from Roland: * "extend config_ext.gears[] from 6 to 8 entries" (also used for boostcontrol) ** it turned out that implementing that in firmware + VemsTune would NOT be a solution for them (0..7 or 1..8 displayed would be misleading) ** if android Vemsdisplay is used in triggerframe mode (not AIM mode), than it sees mcp3208 analog inputs: would be possible to configure the voltages there, and display 0-6 and some special symbol for R (perhaps 7 or 8 or 9, but note that it is a special case: non-monotonous) This wish would be considered normal priority (instead of low) had config + vemslog been provided, + voltages of the actual gearbox model documented ---- '''Save gauges layout''' * show Km / Liter ** you means instead of 8.0 liter / 100 km, show 12.5 km / liter ? (probably also useful for miles / liter or miles / gallon depending on configuaration) * "Read / write from android device." ** save layout of gauges (perhaps to some unique ID/key), to be restored on another device with similar X/Y screen aspect ratio (editing gauges is laborsome) ---- ** Analog input change passing 2.5v on a specified analog channel will force vemsdisplay to change its display page, this is for cars with mounted android tablets and used as a dash, a button press will change pages ---- '''Running out of descriptors (??)''' * traditionally there are only 6 free analog (mcp) channels (+2 EGT + 7 other pre-assigned analogs) ** and 14 fully customisable predefined descriptors for them, running out ? ** Must be some misanderstanding (other than the message sent to the wrong channel, we cannot understand the use-case). ** Please make sure the intended usecase is crystal clear (with reference to project page: what is already set, what else would be, and how; otherwise it cannot be handled, or even verified that it's satisfied or not). ---- Since [http://svn.x-dsl.hu/android/ 2017-02-xx beta] (and any released) versions '''DONE: oilpressure and fuelpressure also sent in AIM stream''' http://vems.hu/android/screenshots/images/oilpressure_fuelpressure.png
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.