####   
 ##  ##  
 ######  
 ##      
  ####   
         

    ###  
   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
         

 _______ 
(  ____ \
| (    \/
| (_____ 
(_____  )
      ) |
/\____) |
\_______)
         

  _   _ 
 | \ | |
 |  \| |
 | . ` |
 | |\  |
 |_| \_|
        
        

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
---- low priority: '''More than 6 gears displayed in VemsDisplay''', sequential gearbox Some sequential gearbox have 8 gears, voltage climbing in this order: * reverse (lowest voltage) * neutral (0) * gear 1-6 original "request" from Roland: * "extend config_ext.gears[] from 6 to 8 entries" (also used for boostcontrol) ** it turned out that implementing that in firmware + VemsTune would NOT be a solution for them (0..7 or 1..8 displayed would be misleading) ** if VemsDisplay is used in triggerframe mode (not AIM mode), than it sees mcp3208 analog inputs: would be possible to configure the voltages there, and display 0-6 and some special symbol for R (perhaps 7 or 8 or 9, but note that it is a special case: non-monotonous) This wish would be considered normal priority (instead of low) had config + vemslog been provided, + voltages of the actual gearbox model documented
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.