###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
#### ### 
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

     ##  
         
    ###  
     ##  
     ##  
 ##  ##  
 ##  ##  
  ####   

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Today i put vems on honda s2000 stroker(2.7l) with sequential gearbox(quaife). Gearbox also has drum sensor. It's true, firmware was tested with sane drumsensor, and configured properly. Either just proper configuration needed, or maybe firmware-modification for weird drumsensor. Problem is that gear box has strange outputs (non-monotonous: doesn't rise all the time). So 1st gear is 0.98V, 2nd 0.37V, 3rd 4.51V, 4th 3.86V,5th 3.31V,6th 2.76V * '''sorted: 0.37V, 0.98V, 2.76V, 3.31V, 3.86V, 4.51V''' ** of course gears are "renamed" but shiftcut should still work if the drumsensor outputs consistent voltage But look at log, vems has problem with detecting gear. http://www.vems.hu/files/DamirMuha/1.2.11/DrumSensorv3.3_u006633-2013.03.18-16.09.19.vemslog Engine is off and it's easy to see voltage between gears that can use for shift cut. * voltage should not be "between gears" ... if configured properly. Does the voltage (measured with DVM) change .... "float" ? ** are the grounds done properly ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.