####   
 ##  ##  
 ######  
 ##      
 ##      
  ####   
         

  ___ 
 |_ _|
  | | 
  | | 
 |___|
      

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

 _______ 
(       )
| () () |
| || || |
| |(_)| |
| |   | |
| )   ( |
|/     \|
         

 ______  
(  __  \ 
| (  \  )
| |   ) |
| |   | |
| |   ) |
| (__/  )
(______/ 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
||MembersPage/Sascha/SchnellEthirtysix||MembersPage/Sascha|| Not really sure what is going on here, but none of my IGN outputs are working... The box is installed in my (M52 w/ HALL/HALL setup) E36 BMW, I had to convert the box from VR to Hall on the pri trigger, everything else seems to work just fine (P259, INJ, etc) but I cannot get any reaction from any of the IGN outputs no matter what I configure them as even in "test mode" Any ideas? I've tried reloading and changing firmwares and nothing has helped. 12+ and GND, and EC36 pinouts have has been verified and tested ok... using an LED to test the outputs. here is one of the cfg's: http://vems.hu/vemstune/sharingcenter/reports.php?cmd=view&key=5wb985 so just to re-cap.. this is what I did to the board to switch from VR to HALL is there something that I could have done here in the process like bridge trig1 that could have damaged something?? or by changing/removing a resistor? http://vems.ca/other/trigger_mod.jpg I followed the V3.3 instructions from this page: http://www.vems.hu/wiki/index.php?page=GenBoard%2FManual%2FInputTriggerHardWare soldering JP2 & JP7 didn't work for me.. the pri trigger didn't work with that soldered, but started to work with it unsoldered changed R30 to 2k4 removed R56 completely, soldered blob @ SJ2, removed blob @ SJ6 Measured the blob @ SJ2 and have 3.8V to GND with hall sensor unplugged and the trigger's (both pri/sec working wonderfully)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.