___ 
  |_  |
    | |
    | |
/\__/ /
\____/ 
       
       

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

    ##   
         
    ##   
    ##   
    ##   
    ##   
    ##   
  ###    

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

         
         
 ##  ##  
 ####### 
 ####### 
 ## # ## 
 ##   ## 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
This is my wiring right now (27 jan 2008) Fuses keep blowing up when I crank the engine. Coils pin 34 and 36 both use the same fuse. Should I give the their own use? EC36 Pin Signal Name Max Load EC36-1 Throttle Position Sensor signal EC36-2 Intake Air Temperature signal EC36-3 EC36-4 EC36-5 High-Power Ground (GND5) EC36-6 EC36-7 Injector 1 10A EC36-8 Injector 3 10A EC36-9 EC36-10 Coil #7 7A EC36-11 Coil #4 7A EC36-12 EC36-13 Secondary Trigger EC36-14 Coolant Temperature signal EC36-15 Fuel Pump relay 350mA EC36-16 EC36-17 EC36-18 EC36-19 Injector 2 10A EC36-20 Injector 4 10A EC36-21 High-Power Ground (GND5) EC36-22 Unassigned EC36-23 Flyback Rail EC36-24 Coil #6 7A EC36-25 Vbatt (Switched with ignition - hot in start and on positions) EC36-26 Ground (ECU and signal GND, eg. VR-, CLT, IAT) EC36-27 Primary Trigger EC36-28 +5V (to sensors) EC36-29 EC36-30 Drive_11 (misc output) 350mA EC36-31 Drive_10 (misc output) 350mA EC36-32 High-Power Ground (GND5) EC36-33 EC36-34 Coil #2 10A EC36-35 EC36-36 Coil #3 10A
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.