___ ( _`\ | (_(_) | _)_ | (_( ) (____/'
____ / ___| \___ \ ___) | |____/
##### ## ## ## ## ##
_______ |__ __| | | | | | | |_|
# # # ### ## # # # # # # #
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: *How do I convert the triggerlog file from the terminal. To a readable file? ** See InputTrigger/TriggerLog ** not very important for HALL sensor though: you will see wheel errors (or no trigger at all) if something is misconnected. Not as critical as for VR, that can, in some cases seem like it's working and only byte at high RPM or other cases. How should I setup the trigger ? 1.1.x firmware (1.1.27). Should work with 1.0.7x as well (actually, many variables are don't care in 1.0.x but best to set those anyway for easier upgrade later.) Seems you got the special N-1 enabled, good * primary_trigger=11 * tooth_wheel=0B * another_trigger_tooth=06 * tooth_wheel_twidth1=78 * tooth_wheel_twidth2=00 (not F0 !) ** since 360 degrees/ 12 tooth=30 degrees per tooth (120 quarterdeg = 0x78) * h[1]=00 06 00 06 .. .. .. .. It's possible to start wasted spark first, ign_dualout can help with this. Camsync can be enabled later. * secondary_trigger=02 ** to disable sectrig For ign_dualout to work, wire paired cylinders to neighbor ignition channel. Like: * cyl1,4 to ignch3,ignch2 * cyl2,3 to ignch7,ignch6 http://i196.photobucket.com/albums/aa262/shushu4345/primary-trigger.jpg http://i196.photobucket.com/albums/aa262/shushu4345/secondairy.jpg http://i196.photobucket.com/albums/aa262/shushu4345/Afbeelding009.jpg http://i196.photobucket.com/albums/aa262/shushu4345/12.jpg Primary trigger Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.