##    
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

  _____  
 |  __ \ 
 | |__) |
 |  ___/ 
 | |     
 |_|     
         
         

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

    ###  
   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
         

   #     
   #     
 #####   
   #     
   #     
   #  #  
    ##   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Peugeot 406 Coupe 3.0 V6 XFX I have huge problems about primary trigger. Please help. I installed several vems v3 but this is new for me. Car has only one crankshaft sensor (VR) on flywheel with 58-2 wheel. Running on Wasted spark. The VR sensor has 3 pin. (OE number 9622209880) Signal GND Shield Double check polar?ty. The sensor has 330ohm. The signal in trigger log is great. Looks everything good. The car started with some trigger error but running. After 10 sec the engine stall with trigger error (less PR trig). Then never ever comes any trigger spike or something in the trigger log. RPM signal gone. I have another vems ecu too. Changed them. Same. Car starts running few sec and shut down. Then no signal ever. Seems both ecu trigger dead.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.