####### 
 ##  ##  
    ##   
   ##    
  ##  ## 
 ####### 
         

 _______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

   ##    
    #    
    #    
    #    
    #    
    #    
   ###   
         

 _     _ 
( )   ( )
`\`\_/'/'
  `\ /'  
   | |   
   (_)   
         
         

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
=== Current VEMS Projects === ''' GenBoard/VerThree '''\\ This is the '''full-featured ECM solution'''. Anything you name, most likely v3 does it already, or it just need software support. ''' AfreshTiny '''\\ The AfreshTiny is the working name for the VEMS round 52mm WideBand 02 meter. Rather simple compared to v3: wideband, EGT and boostcontrol with dual LED display. Round v2 has additional inputs and outputs, with '''3 independent control loops''': * '''analoginput''' => boostcontrol ** two or three control loops can use different analog inputs, or alternatively some can be configured to use: * '''frequency input''' => RPM-target (idlecontrol or powerplant frequency control) * '''K-thermocouple temperature''' (EGT Exhaust temperature, or other temp) input => water injection, or spray ** useful for cooling or industrial process related control (producer gas plants also) ---- === Future VEMS Projects === ''' VemsFrontier/Boards '''\\ This is a set of boards with less features than v3, but good networking capabilities. Mostly ARM based. Big power, but economical manufacturing is a concern. Some of them are very close to manufacturing. ---- === Obsolete VEMS Projects === These boards were experimental (used for prototyping, verify ideas or calibrate values) and '''will not be manufactured in the future''' ''' GenBoard/VerTwo '''\\ This was our first ECM solution, before v3. The same firmware source is used as for v3, but recompile is needed with GENBOARD in my_make instead of GENBOARDv3. This means firmware support is not dropped, even some new features are available from time to time (if compile problem is reported, it will be fixed on demand).
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.