## ##### ## ## ##### ## ##### ## ## #####
# # # # ## # # # #
## ## #### ## #### ## ##
## ## ## ## ## ## #### ##
_____ (___ ) | | _ | | ( )_| | `\___/'
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: '''Fitting guide for Vag oem 60-2 trigger wheel''' '''Oem part numbers''' * Triggerwheel 030103171H * Hallsensor 030906433Q '''How to''' * I chose to drill and tap the offset hole on the block. Caution it will go trough block so use Rtv on that bolt * The block needs to be grinded down to clear the Hall sensor * Use Rtv around the trigger flange not the usual paper gasket * To not press the triggerwheel on to far, gently tap it on the crank and press it on with help of the flywheel. use the orange clip for TDC alignment * Now it should be around tooth 14 * Clear and Grind down the backing plate to make it fit over trigger assembly * It will now start if you select the default Vag 60-2 trigger Setup in Vems. fine tune from there Oem vw crankshaft with trigger wheel is around tooth ~14 In Megasquirt around 78-84 ---- http://www.vems.hu/files/PatrikGolf2/Triggerdelar2.png http://www.vems.hu/files/PatrikGolf2/Triggerg?ngning2.png http://www.vems.hu/files/PatrikGolf2/Trigerslipning2.png http://www.vems.hu/files/PatrikGolf2/Triggerrtv2.png http://www.vems.hu/files/PatrikGolf2/Triggerg?ngad2.png http://www.vems.hu/files/PatrikGolf2/Triggerpl?t2.png Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.