##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

    ###  
   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
         

  _____ 
 |  ___|
 | |_   
 |  _|  
 |_|    
        

 _   _ 
( ) ( )
| | | |
| | | |
| (_) |
(_____)
       
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Current Project : Hayabusa 1300cc engine Short description 4 Cylinders Bore 81mm Stroke 63mm 4 injectors 24lbs 4 COP spark plugs VR sensor on Crank VR sensor on Cam Modified engine with lots of compression Progress until now : Stock wheel on crank has 8 evenly spaced teeth. We have modified this wheel so now it has 24-2 teeth. The stock injectors are placed under the butterfly, this was modified so the injector are above the throttle bodies. Do i set setting to port or throttle body? I am familiar with this kind of tooth wheel. When i crank the engine with the spark plugs removed, i can adjust the reference as i wish. When i crank it with the plugs installed, the RPM is so irregular that i cannot get the engine to start, not even with the adv filter. I've recorded the signal and put it at http://www.vems.hu/files/MustangStef/Hayabusa/busacrank.wav The same wheel on a standard engine with normal compression works just fine. Is it possible to extend the range of the adv filter? When i strobe the engine with spark plugs installed, i find tdc on 90°, whereas the same procedure without spark plugs installed gives 63° degrees. Ignition timing is way off during cranking. I can solve this by using 90° reference and offset my sparkmap with 27 degrees. Wouldnt it be possible to have a negative advance during cranking? When we pull the car it starts, and everything seems normal. I have the tables and config but with the filter setup for the standard engine : http://www.vems.hu/files/MustangStef/Hayabusa/config.txt http://www.vems.hu/files/MustangStef/Hayabusa/tables.txt 15 APRIL 2008 : Tried to feed the starter with 24V instead of 12V. Cranking rpm goes up to 510 rpm. In this setup engine starts very well. I dont have any trigger errors anymore. Still i would like to be able to start on 12V. Anyone has any ideas?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.