__     __
 \ \   / /
  \ \_/ / 
   \   /  
    | |   
    |_|   
          
          

         
         
 ##  ##  
 ######  
 ######  
 ##  ##  
 ##  ##  
         

 _____ 
|  _  |
| | | |
| | | |
\ \/' /
 \_/\_\
       
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

  _    _ 
 | |  | |
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Using Vemstune 1.3.1 ,VEMS 3.6 (writes on the order receipt) but Vemstune recognise it like v3.3, firmware 1.2.2. Engine code: S50B32 Specs: *6 cylinder in line *Infinite variable camshaft angle on both intake and exhaust(VANOS) *displacement (cm3): 3201 *Stock pistons&rods , 3.5mm Cometic Headgasket and ARP hardware *Coil on plugs and full sequential *Stock cams *Precision Turbo 6262turbo *3 vr sensors *Crank 60-2 *Exhaust 6+1 *Intake 6 *Dual Vanos Enabled Started the engine in stock form, nothing changed, i only attached my ecu adapter socket to the car's original ecu socket. I wanted , for the start to verify vanos functionality. I have problems in getting a stable secondary and third trigger, also, secondary and third triggers tries to follow target cam advance maps, but not with very good success. I have manually put cams in max advance and retard position , and took note of them, after that i have made cam target maps.I have attached leds to solenoid outputs, and they are very unstable, even if in close proximity of cam target. I suspect an unstable trigger signals. I attach two trigger logs, one only cranking and one at idle, a config file, and a log.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.