##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

         
### ###  
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ### ## 
         

         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

__   __
\ \ / /
 \ V / 
 /   \ 
/ /^\ \
\/   \/
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hello Everyone, Here is a short description of the project I have in mind. *The victim is a 1988 Alfa Romeo Milano v6. *This is a 3.0 60 degree even fire V6. *Two valves per cylinder overhead cam. *Stock it has a Bosch L-jet system. *This engine quite restricted by the L-jet systems flow *May replace with homebrew ITBs. *Engine harness can be unplugged from ECU harness. ---- Some VEMs ECU features Id like to include initially: * EGT (two EGT channels are possible, and now both channels can be logged) * WB02 * Coil on Plug (6) non-logic style * Offboard MAP sensor. * Crank and Cam VR pickups ---- Can I get some comments on this order list? * Assembled v3.3 controller ** 1-wire interface no ** ignition driver 6+2 ** Knock and EGT knock and 2 EGT ** LCD and PS2 yes ** MAP connection offboard(electronic) ** PowerFlyback yes ** primary_trigger VR ** secondary_trigger auditrigger (yes, order auditrigger for two VR pickups) *1 x Econoseal18-harness *1 x Econoseal36-harness *6 x Injector connector *1 x Wideband O2 sensor *1 x Wideband connector *1 x 400/250 kPa MAP sensor (has connector with it ?) *1 x LCD4x20 *3 x Sealed sensor connector *2 x K-thermocouple connector Q.I see many VR pickups recommend shielded cable to the ECU but the harness has individual wires. * Whats the proper way to wire this up? ** wire shiled on the ECM side only (so shield is not used for signal! obviously min 2 wire + shield needed) * What inline connector could be used? ** sealed sensor connector (WebShop, Loom connector) Q2. I want to use an offboard map sensor. Does anyone know if one from the auto parts store will work? (U.S. based )
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.