__        __
 \ \      / /
  \ \ /\ / / 
   \ V  V /  
    \_/\_/   
             

 _______ 
(  ___  )
| (   ) |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

 _   _ 
( ) ( )
| |/'/'
| , <  
| |\`\ 
(_) (_)
       
       

      #  
      #  
  ### #  
 #   ##  
 #    #  
 #   ##  
  ### #  
         

    ##   
         
    ##   
    ##   
    ##   
    ##   
    ##   
  ###    

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
* ''' Trouble configuring sequential trigger! ''' * ''' is this also called camsync ? ''' * ''' Trigger setup for Alfa 60 deg V6 ''' * ''' Already has 60-2 VR bosch wheel ''' * ''' Sequential ignition desired ''' * ''' six logic level GM coils aquired ''' * ''' Vems ordered with "auditrigger" feature ''' ---- === Bench testing === * m582_1740_200_20_1000_1000.wav * wav file sent using audacity * primary trigger EC36-27 * secondary trigger EC36-13 (is this correct ?) * Works in wasted mode according to megatune * lots of trigger errors with secondary trigger enabled cause I have no clue what vems needs to know. === Questions === * Need to upload a little cad drawing of trigger setup to use in discussion. How is that done. * Are megatune values always specified as degrees or are some specified as 0-255 values. * current config values: rpmk[0]=07 rpmk[1]=D0 primary_trigger=01 secondary_trigger=11 tooth_wheel=3A trigger_tooth=07 another_trigger_tooth=14 crank_minper=9C tooth_wheel_twidth1=02 tooth_wheel_twidth2=06 cam_sync_r_edge_phase=3C cam_sync_f_edge_phase=50 reset_engphase_after=F0 ign_tdcdelayign_tdcdelay=B0
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.