______
 |___  /
    / / 
   / /  
  / /__ 
 /_____|
        
        

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

  ___ 
 |_ _|
  | | 
  | | 
 |___|
      

 _______ 
(  ____ \
| (    \/
| |      
| | ____ 
| | \_  )
| (___) |
(_______)
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
HI. I have a problem with missfires on a Volvo S60 R machine. It runs with VAG 115 coils and it '''runs fine up till 1.6 bars boost, 420bhp'''. But when it boost more, up to 1.8 bar, it starts to studder, one or more cylinders misfires. We run NGK BCP7RES plugs, with 0.5mm gap. The coils are all new, and ao is the plugs. The injectors have been checked for flow and were within 5%. The compression os also good on all cylinders. And the problem only appears on full load on 4th and 5th gear at max torque. I suspect that because we run on 4 stepper outputs, the 5th coil runs on a logic output this might be the problem. And my question is, could a to low pull-up be the problem? How much do the VAG115F coils need to give good opperation? ---- The VAG 115F should work without problems on both stepper and logic out outputs but when using logic out make sure you have applied the double 510 ohm resistor series (resulting in ~255 ohm resistance between hc259 and logic output pin). * for logic ignout, 255 Ohm should be standard on all v3.8 ** some earlier boards might need manual application of the second 510r resistors to logic out channels (from rescuekit (marked 510 or 5100)). ** with ECU powered, the '''logic ignout''' pulls to GND (so -5V can be measured with 5V as a base): It is recommended to measure voltage with a 2k7 pullup to +5V: ** 5/(2700 / 255 +1) = 0.43 V measured (appr.) if 255 Ohm internal ** 5/(2700 / 510 +1) = 0.8 V measured (appr.) if 510 Ohm internal ** take note of the measurement.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.