###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
#### ### 
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ###### 
         

         
### #### 
 ##  ##  
 ##  ##  
 ##  ##  
 ######  
     ##  
 #####   

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
         
  ###    
     #   
  ####   
 #   #   
  ### #  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
for the interested, link to what we do : http://www.mustangautocross.be Has anyone done sequential injection and ignition? Yes. Seq. inj was there since the early days of GenBoard/VerThree. Direct ignition: MembersPage/DaveBrul, MembersPage/MichaelKristensen and MembersPage/MarcellGal. Actually, code for direct ign is going from experimental to production these days. Is it correct that current firmware supports one channel for ignition? No. See ''config.ignchmax'' in firmware. Edis.c looks up the mapping from h[2] (h table, line 2). ''config.reset_engphase_after'' is useful too. Not documented though :-( Trying to find out what parameters (go through GenBoard/InitialConfig) I need to define for my application (4-cyl 1300cc hayabusa engine,12.000rpm max): I have -Vr sensor on camshaft that gives 1 puls per camshaft rotation (pin on camshaft that passes VR sensor) -Vr sensor on crankshaft that gives 8 pulses per crank-rotation -TPS -MAP -Water temperature -Inlet Air temperature -4 separate coil-on-plug Do i need to modify timing.c? I don't think so. But you can review it. This looks a traditional direct ignition + sequential injection setup. Can i modify ignition tables with GenBoard/MenuSystem ? Yes, of course. But simplest way is to use realworld crankdegree units in tables.txt, eg.: <code> numberformat=real n[0]= 18.4 19 21.3 22.4 25.5 29.9 34.5 38.3 n[1]= ... </code> and convert with ''make mtt'' and upload the mtt file with TerminalProgram. When you have the basic map, easiest to tune with MegaTune using the ''mtf'' command to switch to ignition table.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.