###  
   ##    
  #####  
   ##    
   ##    
   ##    
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

         
         
 #    #  
 #    #  
 #    #  
 #   ##  
  ### #  
         

 __      __
 \ \    / /
  \ \  / / 
   \ \/ /  
    \  /   
     \/    
           
           

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Sub-page for questions for MembersPage/SteenAndersen === Questions === I downloaded and compiled the new release [release 1.0.11 since 2004-11-24] from GenBoard/UnderDevelopment/FirmwareChanges page. I Can'not get the WBO2 to work right. '''How do i turn on WBO2 without issuing mde02 command ? (when engine starts)''' If i send '''mde02''' command it starts WBO2, and it works fine, but not the egoC:, on display on LCD stays on 0.00. ''A: EGO correction can be disabled in several ways, for cold engine, low RPM, high MAP, etc.. see config.ego_.... variables.'' In GenBoard/Manual/Config/WBoxygen it say's to "set <code> config13 = 0x02 </code> nothing happens when i turn on the engine, LCD shows La:?.??. and on lcd page 7, wbo2 is OFF. ''It is very likely that your RPM reads 0000 because trigger is not enabled or applied.'' I do have RPM readings, and pw, iat, clt, and mat is OK on LCD. The problem is ''secondary_trigger=FF''. Check GenBoard/UnderDevelopment/FirmwareChanges, especially anything about secondary_trigger (or changes after v8 release). Try secondary_trigger=02 ---- My subpage for questions that i need an answer to. Questions witch i have solved or feel is answered is moved to MembersPage/SteenAndersen/History page ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.