####   
 ##      
 ##      
 ##      
  ####   
         

   ##    
         
  ###    
   ##    
   ##    
   ##    
  ####   
         

 _______ 
/ ___   )
\/   )  |
    /   )
   /   / 
  /   /  
 /   (_/\
(_______/
         

         
         
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Sub-page for questions for MembersPage/SteenAndersen === Questions === My subpage for questions that i need an answer to. Questions witch i have solved or feel is answered is moved to MembersPage/SteenAndersen/History page ---- I downloaded and compiled the new release [release 1.0.11 since 2004-11-24]from GenBoard/UnderDevelopment/FirmwareChanges page. I Can'not get the WBO2 to work right. In GenBoard/Manual/Config/WBoxygen it say's to "set config.config13 bit1=1 to enable WBO2 ", so my <code> config13 = 0x02 </code> should be right, also cheked others config.txt to confirm. But nothing happens when i turn on the engine, LCD shows ?.??. If i send '''mde02''' command it starts WBO2, and it works fine, but not the egoC:, no display on LCD stays on 0.00 How do i turn on WBO2 without issuing a command ? (when board starts) Also on the LCD, there seems to be some minor errors, on one page (think it was page3) a strange looking character was in one position, not a numeric or alphabetic character. Also i don't have egt: sensor and would like Vbatt, or Engine status (S=Startup,A=Accelerating,D=Decelerating ...) in page 1 on LCD. I looked in lcd_display.c and found <code> PGM_VOID_P lcd_line_03[] PROGMEM = { lcd_pw, lcd_space, #ifdef LCD_IAC_PREFERRED lcd_iacstr, lcd_iacpos, #else // display EGT lcd_egtstr, lcd_egt1, #endif // LCD_IAC_PREFERRED lcd_idlerpm, LINEEND2 }; </code> Maybe one could put an option to display Vbat and engine status. All of the above problems where not present when i had v.8 of firmware uploaded in vems. So it's like new bug's or undocumented features.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.