##### ## ## ## ## ##### ## ##
### # # ## # ## ### # # ####
### ## ### ## ## ## ## ## ### ## ## ## ###
## ## ## ## ## ## ## ## #####
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: Sub page for MembersPage/SteenAndersen == My Progress status == This page should describe my progress, only current status here, old status moved to MembersPage/SteenAndersen/History ---- 14. Aug. 2005 I have been very sick (hopitalized) and have not played with cars for a time, but now i slowly started up again. I the last few month i have run the VEMS as a measuring system in my car, and collected parts to use for injection. I had a complete intake from a 91' with injectors, fuel lines, idle valve, and pressure regulator. So now i need to fabricate some adapters to mount the intake. I made some testing on the desktop, with all injector's and Idle valve connected, and using mstxx mspxx commands and megatune. So far i found some issues that need to be solved before vems is controlling my car. * The idle solenoide PWM frequency has to go down to around 100Hz, since right now vems is frying the valve. * The temperature range has to go higher than the 101°C that it supports now. But i'm not clear about what to do with all the config parameters if i just change numbers in in the '''termfactor.c''' what/where to change. And I like to use Celcius + 100 as temp bins giving a -100 to 155 range. * I'm still not sure about my trigger setup, so far the rpm meter's signal has seem ok, but i still consider 36-1 at crank, and thinking about how to implement the 2.trigger for fully sequential injection. * Stil unsure about ignition. I have not had success to test the Ignition output from vems with the LED connected to +12 and IGN_xx from vems, it flickers very uneven making me questioning my trigger signal. I may have to take a timing light apart to make a test light. ---- Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.