_________
\__   __/
   ) (   
   | |   
   | |   
   | |   
___) (___
\_______/
         

______ 
|  _  \
| | | |
| | | |
| |/ / 
|___/  
       
       

         
 ####### 
 ##  ##  
    ##   
   ##    
  ##  ## 
 ####### 
         

  _   _ 
 | \ | |
 |  \| |
 | . ` |
 | |\  |
 |_| \_|
        
        

   ###   
  ## ##  
  ##     
 ####    
  ##     
  ##     
 ####    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Started 25.Oct.2007 This will be a ongoing discussion on the build up of a new VEMS V3.3 and build of a wiring loom to handle a M20 or M30 engine in a BMW E30 series. Loom will be able to handle a stock NA engine as well as a Forced induction setup along with boost control, wideband signal and EGT signal. Loom will be able to be installed into any E30 with a identical C101 plug (where the engine loom connects into the car). Install when loom is ready should take about 30-40minutes. _____________________________________________________________ Update 29.Oct.2007 Before anything is done one needs to install the remaining components, wich are only few on the V3.3 board vs. the older ones. http://www.vems.hu/wiki/index.php?page=StepByStepGuide Shows most of the information I was looking for, whilst I still need some more information. Question with answers in the StebBystepGuide #1. Installation of the FET and IGTB´s and final look before installing the board into the case. #2. And where do IGTB´s go and where to the FET´s go.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.