##  ##  
 ######  
 ######  
 ##  ##  
 ##  ##  
         

         
         
 #    #  
  #  #   
   ##    
  #  #   
 #    #  
         

   _____ 
  / ____|
 | (___  
  \___ \ 
  ____) |
 |_____/ 
         
         

   _____ 
  / ____|
 | (___  
  \___ \ 
  ____) |
 |_____/ 
         
         

  ____  
 | __ ) 
 |  _ \ 
 | |_) |
 |____/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Wheelspeed 2 Input''' What with the amazing firmware update 1.2.38 I need to consider wheelspeed 2 for traction control, I think it would be rude not to use it! Looking at InputTrigger/WheelSpeed it says to use the SCL pin on the processor. The real question is this *looking at GenBoard/VerThree/Schematic for GenBoard V3.8, it shows circuitry between JP13 SCL-in and SCL on the processor that was never there on older boards. *Is this the correct protection circuit for wheelspeed 2? **This is a sensitive connection so I need to be confident it won't end in smoke, I'm tired of that in the past. Advice welcome. I'm going to need the traction control with 250hp in a small lightweight car!!
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.