_____ 
|_   _|
  | |  
  | |  
  | |  
  \_/  
       
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

         
|\     /|
| )   ( |
| |   | |
( (   ) )
 \ \_/ / 
  \   /  
   \_/   
         

______ 
| ___ \
| |_/ /
|    / 
| |\ \ 
\_| \_|
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Wheelspeed 2 Input''' What with the amazing firmware update 1.2.38 I need to consider wheelspeed 2 for traction control, I think it would be rude not to use it! Looking at InputTrigger/WheelSpeed it says to use the SCL pin on the processor. The real question is this *looking at GenBoard/VerThree/Schematic for GenBoard V3.8, it shows circuitry between JP13 SCL-in and SCL on the processor that was never there on older boards. *Is this the correct protection circuit for wheelspeed 2? **This is a sensitive connection so I need to be confident it won't end in smoke, I'm tired of that in the past. Advice welcome. I'm going to need the traction control with 250hp in a small lightweight car!!
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.