##    
         
  ###    
   ##    
   ##    
   ##    
  ####   
         

 _       _ 
( )  _  ( )
| | ( ) | |
| | | | | |
| (_/ \_) |
`\___x___/'
           
           

     ### 
  #####  
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ### ## 
         

  ###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

         
         
  ####   
 #    #  
 #       
 #    #  
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
All older information previously on this page can be found here MembersPage/Sprocket/OldorObsoliteInformation All latest information shall follow, since this is the same project, just the latest progression. ---- '''Introduction''' The Austin/ Morris/ British Leyland/ Rover legendary A Series engine which has its roots back in the 1950's where long stroke engines were favoured as a result of taxes imposed on cylinder size. Would anyone believe then, the A series engine would be so durable and yeild power figures as they do Today? Here's how it's done. '''Brief overview of the Engine''' A BMW K1100 (motorcycle) 16v Twin cam cylinder head engineered onto Rover A+ Series engine and transmission. *Choce of OEM camshaft sets. GT, LT or RS. I have installed the low duration GT inlet with the slightly longer duration LT exhaust. *Cam timing set for 115 inlet and 110 exhaust. *Engine is a 1996 onwards 1275cc MPi block over bored +0.5mm. *Accralite 18cc dish forged pistons, at 1293cc and compression 8.5:1. **Now increased to 9.0:1 *Standard crankshaft, Nitrided. *Mitsubishi TD04HL-15T turbocharger from a SAAB 93/95. *Transmission is an uprated straight cut gearset with a Quaife ATB diff. **Transmission now replaced with up rated helical gear set (oh the silence is bliss) *Similar combination already dyno'd at 268hp on 20Psi boost. '''Hardware''' *Toyota Yaris COP Ignition coils 90919-02240 *Bosch 'Green Giant' 0280155968 injectors *3bar Pierburg rail integrated fuel pressure regulator (adapted from some sort of Audi V6) *Walbro 255 in tank fuel pump *Bosch 0 280 122 001 Throttle Position Sensor *Bosch 0 281 002 401 (038 906 051 C) MAT/MAP 3bar sensor *VR Primary trigger 36-4 (Rover Mini Mpi) (also Rover-K Lotus-Elise e324) *VR Secondary trigger. Custom setup sensing one longer bolt on inlet camshaft drive sprocket. *Bosch generic 'blue' CLT sensor *Stepper motor IAC Valve Taken from a Rover K Series VVC *Pierburg Boost solenoid *RTS Verto clutch. A modified standard unit assembled from two standard clutches. '''Set up and config to follow''' It's tight for space! http://www.turbominis.co.uk/uploads/i/wh960-oe1/sprocket-2963.jpg Not worked on the car much over the last couple of years, but 2017 will hopefully a fun and powerful one! http://www.turbominis.co.uk/uploads/i/wh960-oe1/sprocket-2968.jpg ---- MembersPage/Sprocket/ECpinUsage '''ECU Pin Usage''' MembersPage/Sprocket/CoilOnPlug '''Coil On Plug''' MembersPage/Sprocket/LogicLevelOut '''Logic Outputs''' MembersPage/Sprocket/EvaporativeEmissions '''Evaporative Emissions Purge Valve''' MembersPage/Sprocket/BoostControl '''Boost Control''' MembersPage/Sprocket/GPS '''GPS Logging''' MembersPage/Sprocket/Bluetooth '''Bluetooth''' MembersPage/Sprocket/NoisyTPS '''Noisy 5v+ supply (Fluttering MAP/TPS)''' MembersPage/Sprocket/AnalogInputs '''Analog Inputs''' MembersPage/Sprocket/WheelspeedTwo '''Wheelspeed 2 Input''' MembersPage/Sprocket/MatMapSensor '''MAT MAP sensor''' MembersPage/Sprocket/Ethanol '''E85''' MembersPage/Sprocket/VemsTuneTweaks '''VemsTune Tips and Tricks''' MembersPage/Sprocket/WideBandRiTarget '''Wideband Ri Target''' MembersPage/Sprocket/ECUFusing '''Safe Fusing of the ECU''' MembersPage/Sprocket/ErrorReports '''Error Reports''' MembersPage/Sprocket/RoverSpiTrigger '''Rover Group Single Point Injection 36-1-1 Trigger settings'''
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.